Grease selection

 

Grease selection on application conditions

Verkol S.A. cooperates with the lubrication experts at the company SKF and recommends the consultancy service of the software LUBESELECT featured at @ptitudeXchange, for selecting the adequate greases for specific applications.

Please fill out the following application form and our Support Engineering Department will recommend you the most adequate solution for your requirements, powered by LUBESELECT, in a short time (max. 24 hours).

Entries with * are required.




Date:
Company: *
Contact person: *
E-mail: *

Address: *

City: *
Country: *
Application/Current Lubricant:

 

Dimensions:

Bearing Type *

DGBB ACBB (S/P) CRB (S/V/P)
SABB NRB CARB (S/V)
TRB SRB Y-Bearing

(S = standard, P = high-precision, V = full complement)

Bearing designation:  
Inner diameter * d   mm
Outer diameter * D   mm
Bearing width     mm
Bearing height     mm
Filling type *
Pre-greased
Relubicated
 
Load(C/P) *
Low (> 10)
Medium (5-10)
High (2-5)
Very high (< 2)

 

Operating parameters:

Typical temperature (OR) * ºC
Minimum temperature (start-up) ºC
Maximum temperature (peak) ºC
Speed * RPM
Shock load *
Yes
No
 
Ambiente temperature *
< 35º
> 35º


Special Conditions (Optional)

  Yes No    
Vertical shaft    
Oscillatings movements    
Outer ring rotation    
  not relevant relevant important very important
Central lubrication system
High rust protection
Water resistance
Low noise
Frequent start-up/shutdown
Heavily vibrating installation
Very low friction
Very long grease life
Food compatibility
Biodegradability
Radiation resistance
Constant friction required



Attention: The lubrication recommendation provided by Verkol will be based on the information sent in this form. The lubricant selection advisor gives lubricant selection suggestions, based on generalised selection rules. It cannot take into account every detail of the application, and the selection is made from a limited set of greases and oils. No liability can be accepted for any loss or damage whether direct, indirect or consequential arising out of the use of a lubrication recommendation based on this online form.